Page 21 of 24 Form 0158E 3805 07/14/2008
Superchips Inc
.
Superchips Inc.
1790 East Airport Blvd., Sanford, FL. 32773 (407) 585-7000 http://www.Superchips.com
Superchip & Superchips are registered trademarks of Superchips, Inc.
Recovery Procedure
In the event of a status code during a programming sequence, the FLASHPAQ Tuner will
attempt to recover the vehicle to the original stock program. It is necessary to carefully follow
the screen prompts, possibly requiring multiple “Ignition OFF” and “Ignition ON” sequences, to
correctly return the vehicle to stock settings. See below for model year specific details.
1998.5 - 2002 Ram 5.9 L Cummins Recovery Procedure
Following the on screen prompts, turn ignition off, and
remove the two fuses labeled ENG CONT 1
and ENG CONT 2.
The Power Distribution Center (PDC) is a fuse box located under the hood
attached to the fender on the driver’s side of the vehicle. The figure below shows the diagram that is
printed on the cover of the PDC.
Remove the cover and use the diagram to locate two fuses labeled ENG CONT 1 and ENG
CONT 2. Remove these fuses. Keep them available for re-installation in a short while. When
prompted, re-install the fuses, replace the fuses into the same locations from which they were
removed. Replace the cover on the PDC. When prompted turn the ignition back on.
Status Notification
When recovery is completed your vehicle is returned to factory stock. You are now able to
start your vehicle normally. You may now attempt to use the FLASHPAQ Tuner to program
your vehicle again or to program another vehicle (the tuner is now reset and not locked to a
vehicle). Follow the on-screen prompts. In the event that recovery is unsuccessful, or for
any reason the FLASHPAQ Tuner fails to complete its programming cycle, a status
message will be displayed on the unit. Please make note of the message displayed and
contact Superchips Customer Service.
Page 22 of 24 Form 0158E 3805 07/14/2008
Superchips Inc
.
Superchips Inc.
1790 East Airport Blvd., Sanford, FL. 32773 (407) 585-7000 http://www.Superchips.com
Superchip & Superchips are registered trademarks of Superchips, Inc.
2003 - 2005 Ram 5.9 L Cummins Recovery Procedure
Following the on screen prompts, turn ignition off, and
disconnect the fusible link
. Look for the
(Blue wire labeled
‘fuse link’)
and follow it until you see the connector located near the battery.
(Be aware this blue wire has other colors of wire connected to it). See picture below for
detailed location of connector. When prompted, re-connect fusible link, then when prompted
turn ignition back on.
Status Notification
When recovery is completed your vehicle is returned to factory stock. You are now able to
start your vehicle normally. You may now attempt to use the FLASHPAQ Tuner to program
your vehicle again or to program another vehicle (the tuner is now reset and not locked to a
vehicle). Follow the on-screen prompts. In the event that recovery is unsuccessful, or for
any reason the FLASHPAQ Tuner fails to complete its programming cycle, a status
message will be displayed on the unit. Please make note of the message displayed and
contact Superchips Customer Service.
Fusible Link
(connector).
Blue
Wire
