Superabrasive Lavina 30L-S, Руководство пользователя, Страница: 9 / 34

Superabrasive User Manual Original Language Lavina® 30L ‐ S/ Lavina® 30L ‐ S ‐ HV 8/2014
9
STORAGE
Always store and transport the Lavina® S
machine in a dry place. Never transport the
Lavina® S machine unprotected; it may be
damaged if transported unprotected during
rain or snow.
When storing the machine the temperature
may fall down to or to less than 32F (or 0
o
C) you should empty the water from the system using the following steps:
‐ Pull out the hose of the tank (Fig.3.9)
‐ Using compressed air blow out the water from the system for the two positions of the turn ‐ cock (Fig. 3.10, Fig. 3.11).
MOUNTING OF GUARD ASSEMBLY
Set the machine in the position shown on Fig 3.12, turn the Guard Assembly (Fig 3.13). Pull backwards the Guard Assembly, you
have to be sure that the Tool holders have passed through it (Fig 3.14). Put the Guard Assembly on position (Fig 3.15).
Dismounting must be done in reverse sequence.
4. OPERATION
PRELIMINARY CONTROLS
Inspect the working area as explained in the safety instructions. For wet use, fill the water tank when the electrical cable is
disconnected. Connect the vacuum extractor and ensure that the vacuum hose is clear and that it will easily follow the machine.
Plug in the machine and make sure that the power cord is free to follow the direction of the working
Lavina® S machine.
WATER FLOW CONTROL UNIT
The operator can choose the water sprayer in the front when the tap is in the horizontal position (Fig.4.1), the water
will spray under the cover of the machine
when the level is in the vertical position
(Fig.4.2).The flow regulating valve
located on the tank (Fig.4.2.1) is
increasing or reducing the water flow to
the working area – in front of the
machine or under the main head cover of
the machine/only for machines produced
after Jan. 1 2014/.
ADJUSTING AND MOUNTING TOOLS
Mount the tools only after ensuring that there is enough diamond
bond material left. Be sure that the plates are always clean before
mounting. WARNING: Always secure the “QuickChange” pads with
the security plate (Fig.4.3), lock with the tool holder key (Fig.5.3).
Diamond tools with Velcro are attached to three 13,2 inch foam
plates (Fig.4.4). The foam plates are mounted on the key lock
(butterfly). Always use the tool holder key (Fig.5.3).
Fgure 3.13 Fgure 3.14
Fgure 3.12 Fgure 3.15
Figure 3.9
Figure 3.10
Figure 3.11
Figure 4.2.1
Figure 4.1
Figure 4.2
Figure 4.4 Figure 4.3