• 7 •
6.
Connect the charger to the electrical outlet. The AC POWER
(red)
LED will light.
7.
If you’ve connected everything correctly, the CHARGING
(
yellow/
orange) LED should be lit, indicating that the charger is charging, and the
AC POWER
(red) LED will go off. If the CHARGING
LED does not
light, check the connections or have the battery checked/replaced.
8.
When the battery is fully charged, the CHARGED/MAINTAINING
(green)
LED will pulse.
9.
When charging is complete, disconnect the charger from the AC power,
disconnect the negative clamp, and finally the positive clamp.
10.
A marine (boat) battery must be removed and charged on shore.
USING THE QUICK-CONNECT CABLE CONNECTORS
Connect either of the two output cable assemblies to the charger in a matter of
seconds. Make sure to place the charger on a dry, non-flammable surface.
IMPORTANT:
Never connect the clamp and ring terminal connectors together
for use in other applications, such as external battery or other power source
charging, or to extend the output cable length, as reverse polarity and/or
overcharge conditions will occur.
BATTERY CLAMP QUICK-CONNECT
1.
Connect the end of the charger output cable to the end of the battery
clamp quick-connect.
2.
Follow the steps in previous sections to connect the output clamps to
the battery.
3.
After a good electrical connection is made to the battery, plug the power
cord into a grounded 120V AC electrical wall outlet.
RING TERMINAL QUICK-CONNECT
The ring connectors permanently attach to the battery, providing easy access
to quickly connect the charger to your battery. This application is appropriate
for motorcycles, lawn tractors, ATVs and snowmobiles.
1.
To permanently attach to a battery, loosen and remove each nut from the
bolt at the battery terminal.
2.
Connect the red POSITIVE connector ring to the POSITIVE battery terminal.
3.
Connect the black NEGATIVE connector ring to the NEGATIVE battery
terminal.
4.
Replace and tighten the nuts to secure.
5.
Connect the cable to the end of the charger output cord.
Take care to keep the wires and plug away from metal and moving parts.
6.
Plug the charger’s power cord into a grounded 120V AC electrical wall outlet.
AUTOMATIC CHARGING MODE
When an automatic charge is performed, the charger switches to the maintain
mode automatically after the battery is charged.
