Super Star SS-158EDX, Руководство по обслуживанию, Страница: 7 / 48

6
PROCEDURE TO RECEIVE AND TRANSMIT
A. MICROPHONE
The receiver and transmitter are controlled by the push-to-talk switch on the microphone. Press the
switch and the transmitter is activated, release switch to receive. When transmitting, hold the
microphone two inches from the mouth and speak clearly in a normal voice. This transceiver comes
complete with a low impedance dynamic microphone.
B. PROCEDURE TO RECEIVE
1. Be sure that power source, microphone and antenna are connected to the proper connectors before
going to the next step.
2.
Turn
VOL
knob clockwise to apply power to the radio.
3.
Set the
VOL
for a comfortable listening level.
4.
Set the
MODE
switch to the desired mode.
5.
Listen to the background noise from the speaker. Turn the
SQ
knob slowly clockwise until the
noise just disappears. The
SQ
is now properly adjusted. The receiver will remain quiet until a
signal is actually received. Do not advance the control too far or some of weaker signals will not be
heard.
6.
Set the
CHANNEL
selector switch to the desired channel.
7.
Set the
RF GAIN
control fully clockwise for maximum RF gain.
8.
Adjust the
FINE/COARSE
control to clarify the SSB/CW signals or to optimize AM/FM signals.
C. PROCEDURE TO TANSMIT
1. Select the desired channel of transmission
2.
Set the
MIC GAIN
control fully clockwise.
3.
If the channel is clear, depress the push-to-talk switch on the microphone and speak in a normal
voice.