7
8
Take out the landing gear accessories
(as following) from the hardware bag:
Aluminum landing gear x 1 pc
wheel pants x 2 pcs
M4 x 40mm screw x 2 pcs
4mm nuts x 6 pcs
There is a "dimple" in each side.
Use these dimples as a guide to drill
a 4mm hole completely through the
wheel pant using reamer.
Apply the decal sheet on the wheel
pants.
Using M4 nut to secure the wheel
pant assembly on the aluminum
landing gear. Repeat the same
procedure on another side of wheel
pant assembly.
Find 3 pre-drilled holes on the bottom
of fuselage. Try to locate the
aluminum landing gear over it and
use 3 x 12mm tapping screws to
secure the aluminum landing gear on
the bottom of the fuselage.
Use driller to drill 2mm hole on the
elevator
Place the center of the control horn
on the elevator at the hold drilled in
the previous step. Attached the
elevator control horn using the
hardware provided (M2 x 12mm
screws x 2 pcs) and fasten in place
using a Phillips screwdriver.
Drill 2mm holes on the rudder.
Repeat the same procedure to attach
the rudder
Place a piece of silicone tubing over
the clevis as extra insurance to
prevent the clevis from accidentally
coming open.
Install the servos for rudder, elevator
and throttle. Please note that the
servos must be in neutral position.
Install the battery pack
Use hobby knife to cut off the
covering over the holes on the sides
of fuselage. Insert the fiber tube into
the fuselage. Center the fiber tube
and secure it with instant glue.
