Super angel Juice Extractor, Руководство по эксплуатации

Страница: 11 / 36

In order to avoid damaging the magnetic sensor located at the bottom of extracting
housing, please do not submerge the sensor area of extracting housing in water.
Important! Right after juicing, please clean the surrounding area(white bushing) of
motor shaft by gently spraying water. When spraying water to the surrounding area of
motor shaft, please lift the back of the juicer(bottom part) slightly so that water
doesn’t get into the inside of white bushing. Do not rub the white bushing of motor
shaft with either brush or towel. Just simply dry up the remained water on the white
bushing by gently tapping with soft towel.
a) Slowly insert the cleaning brush into the
Extracting Housing under the running (warm)water.
b) Slowly pull the cleaning brush, while turning clockwise (under the running warm water). Repeat
this step two or three times.
c) Do not pull the cleaning brush out straight from the Extracting Housing. Otherwise, the brush
handle may break.
d) Press the start button to release the gears
from the screen housing. The rotating gears
will push the screen housing and the motor
will stop running within 5 - 6 seconds with
a beep sound.
6. Clean the Extracting Housing & twin grinding
gears with the Cleaning Brush.
In order to extend the life span of juice
extractor, you need to cleand all aprts
immediately right after use, before mineral
build-up.