If the scooter will not move after the re-set, one of
the following indicator light may be displayed:
The magnetic brake either turn off or
connectors are loose.
Batteries on scooter for recharging with
the key switch turn on.
Low voltage of batteries detected by
controller
Potentiometer broken down.
Overload protection.
Battery needs recharging or connection
faulty - check grey color connector.
AUTO SWITCH OFF ELECTRONIC SYSTEM
●
The electronic system of this scooter is protected by a digital over
current cut-off system. If your SupaScoota stops, you will need to
turn the main key switch to the “Off” position, and then switch to “On”
position to reset the system.
●
Possible causes of over current cut-out are battery not fully charged
or near the end of its life, or the slope is too steep for the scooter. Do
not continue to overload the system as this may damage the
controller.
●
The electronic system of this scooter will switch itself “Off” after 3
minutes if the key switch is left in the “On” position when the scooter
is not in use. You will then need to turn the key switch to the “Off”
position, and then switch to “On” position to reset the control system.
- 21 -
ELECTRONIC STABILITY CONTROL (ESC)
This is the most significant advancement in mobility scooter safety ever
designed and will dramatically reduce accidents due to operator
misuse. Turning corners at excessive speed has always been one of
the most common causes of accidents but with clever engineering
and sophisticated electronics we have all but eliminated this problem.
The speed of the SupaScoota is now electronically governed in
direct proportion to the rotation of the handle bars, virtually
eliminating any possibility of over speeding when turning. With the
handle bars at maximum rotation and the throttle at maximum speed
the scooter will turn at a very low speed with complete safety. No
other scooter can provide this level of safety.
Some situations may require maximum power to be used when turning
and we have allowed for this with a handlebar mounted push button
which will disable the ESC for 20 seconds if needed. (Push button
for one second)
Keep fingers and clothing
away from the Electronic Stability
Control sensor.
This vital piece of equipment is very
sensitive and could be damaged, or
could cause damage, if tampered
with.
Warning.
If the ESC is disconnected
or faulty, the scooter will continue
to function normally
but the speed
will not reduce when turning.
- 22 -
Green light quick flashing
Yellow & Red light ON
Green light slow flashing
Green, Red & Yellow light ON
Red & Green light flashing
alternately
Red light ON
