Harness User’s manual
S
UP’AIR
_
STRIKE
_
Page 17
1
2
3
Installing the reserve parachute in its container.
1.
Place the reserve parachute inside
the container, with the handle posi-
tioned upward, and parachute risers
downward.
2.
- Take a small piece of line to help with
the installation procedure.
- Push it through loop #1 ( B flap).
- Using the piece of line, pull the white
loop through the left grommet of the « C
» then « A » flaps.
Installing the reserve parachute.
3.
Secure the installation by pushing
the left side of the yellow cable
through the white loop.
Carefully remove the line.
4.
Using the piece of line pull loop #3
through grommet #4 – flap (D)...
5.
Secure the installation by pushing the
right side of the yellow cable through
the loop cord.
Carefully remove the line.
6.
- Fasten the reserve parachute
handle to the Velcro®
- Push the two outer ends of the reserve
parachute handle inside their respec-
tive housings located on either side of
the handle on the harness.
Check the com-
pleted instal-
lation during a
hang-test.
Have the installation
checked by a profes-
sional outfit.
Conduct an extrac-
tion test every six ( 6
) months to assure
proper system func-
tionality.
Note : conducting and
extraction test does not
imply deploying the re-
serve parachute which
will stay inside its POD.
A
B
C
D
E
B
C
A
B
C
D
A
B
C
D
A
B
C
D
A
B
C
D
