Notice d'utilisation parachute
| FLUID
LIGHT
SUPAIR
|
FLUID
LIGHT
| page 11
- Push the riser’s loop through the
flexible toric ring.
- Push the maillon through the riser’s
loop.
- Give a second twist to the toric ring.
- Push the Maillon Rapide® through
the riser loop.
Repeat sequence
1 through 5 on the
other side of the
harness.
.
- Open the Maillon Rapide®
- Push the bridle’s buckle through.
- Push the maillon through the flexible
toric ring.
- Twist
- Take two (2) square 6mm Maillons Rapides® and two (2) flexible toric rings.
- Unfasten the Velcros (or zip) located alongside the shoulder protective sleeves to reach the reserve parachute connection loops on the shoulder straps.
-
Tidy up the assembly.
- Be certain that the risers end loops are
securely in place.
- Close the maillon tightly by hand.
- Complete tightening with pliers by making a
¼ tightening turn.
Tuck away the risers excess ( without making knots ) under one single flap :
- Either to the right side if you wish to place your reserve parachute handle to the
right ( recommended if right handed ).
- Or to the left side if you wish to place your reserve parachute handle to the left (
recommended if left handed ).
- Close the protective sleeves Velcros (or zip).
Connecting individual reserve parachute
First of all, take care that your reserve is compatible with the harness you want to use with. In case you will use protection accessories (Bumpair, airbag), it must be installed in
the harness first, then check that your rescue fits well in the reserve container, without too much space or compression.
You will need :
-1 x Standard separate Dyneema® risers ( Réf.: ELESOLODYNEEMA )
-1 x 7mm square Maillon Rapide® ( Réf.: MAILCARIN7 )
- 5 x «O» toric rings ( Réf.: MPPP044 )
>> Individual reserve connection : Harness - Separate Risers
1
2
3
4
5
6
7
