User’s manuel
| BUMP STRIKE 2
SUPAIR
| BUMP STRIKE 2
| page 12
What is the influence of the pressure of the protection on the damping performance?
This is difficult to establish precisely. Here is what we can say:
For the standard test: The protection is inflated and tested at the same altitude with a “normal” full inflation pressure at the mouth without
forcing.
At an altitude higher than the take-off altitude, i.e. higher than the inflation altitude, the pressure in the protection increases. Supair’s tests
show a stable shock absorption quality compared to the test conditions.
At an altitude lower than the take-off altitude, and therefore lower than the inflation altitude, the pressure in the protection decreases. We
have tested the half-inflated bag and the result shows that the impact performance is still within the standard, but with lower values than
those measured when the protection is fully inflated.
It is therefore recommended that, after losing a significant flight altitude in relation to the take-off altitude, you reinflate the protection in
flight using the mouthpiece (left, see page 9)
NOTE
Influence of the pressure in the protection on the performance of the damping
Clean the BUMP envelop with water.
For the valve: clean with water and washing-up liquid.
In all cases, do not use thinner or solvent as this could damage the fibres that make up the fabric of your protection.
Cleaning and maintenance
Life span and warranty
This protection is guaranteed for two years. This protection can be used for up to 5 years if there is no air leakage from the pocket and if the
fabric cover is not damaged.
CARE
