USER’S INSTRUCTIONS
ENG
19
10.
INTERCOM FUNCTIONS BETWEEN TWO SUOMY SCS 3LOGY DEVICES
10.1.
ENABLING/DISABLING THE INTERCOM
Keep both
SCS 3LOGY
devices 10 metres away from each other, switched on, and connected to the respective telephones; to establish
intercom connection press the control button on one of the devices and hold it for approximately 2 seconds [(1) see fig-1]until it beeps. At that
point intercommunication between the two
SCS 3LOGY
devices will be enabled.
To disable intercommunication hold the control button on any of the
SCS 3LOGY
devices down for approximately 2 seconds [(1) see fig-1].
10.2.
ADJUSTING THE INTERCOM VOLUME
The volume level can be changed when the
SCS 3LOGY
devices are communicating with each other . Pressing the control button [(1) see fig-
1] changes between three volume levels (low, medium, high, low etc.).
11.
INTERCOMMUNICATION WITH ANOTHER BLUETOOTH® DEVICE FOR AUDIO RECEPTION
Ensure both devices to be connected are switched off.
Press and hold the control button down [(1) see fig-1] on the
SCS 3LOGY
until the LED flashes alternating red and blue.
Put the other Bluetooth® device in connection mode.
Press the control button once on the
SCS 3LOGY
briefly [(1) see fig-1]. In a few seconds both devices will connect and intercommunication
will be established.
Once connected it is advisable to turn the
SCS 3LOGY
off and on until it operates correctly with the telephone and during intercommunication.
Incoming call facilities are still available on the telephone when the
SCS 3LOGY
is communicating with the other device.
Intercommunication is interrupted when there is an incoming call and then re-established when the call ends. The other intercom device will
receive a warning signal. Intercommunication must be disabled before making a call with the
SCS 3LOGY
.
To make a call while in intercom mode first disable the intercom mode (see 10.1), make the call (see 6.3), then re-enable intercom mode (see 10.1).
12.
INTERCOM FUNCTIONS WITH ANOTHER BLUETOOTH® DEVICE FOR AUDIO RECEPTION
12.1.
ENABLING & DISABLING THE INTERCOM
The
SCS 3LOGY
can enable or disable intercommunication with another Bluetooth® device.
To establish the intercom connection both devices should be at least 10 metres apart, switched on, and connected; at this point hold the
SCS
3LOGY
control button down for approximately 2 seconds [(1) see fig-1] until it beeps. Intercommunication has now been enabled.
To disable press and hold down the
SCS 3LOGY
control button for approximately 2 seconds [(1) see fig-1].
15-24 Libretto TEC Bluetooth 3LOGY ENG:Layout 1 26-03-2012 12:15 Pagina 19
