05.
OPERATION
Using the RearVision WSU43
1. Switch your 12-volt DC power port on with your ignition, the monitor wil
start work accordingly, the video signal will be sent from camera and will
be displayed on the monitor.
The image is set to time out in 30 seconds. However if you wish to shut the image
off manually, just touch the “
Touch for Rearview
” Button on the monitor again
anytime to stop at once.
2. If you want to see the backup image when driving your car , just touch the
“
Touch for Rearview
” Button on the top of monitor (see figure 1), or touch
the “
Touch for Rearview
” button of the cigarette lighter adapter(see figure 2).
3. When the vehicle is shut off, power is removed from the monitor
and the monitor will shut off automatically, and the camera will
stop work.
Note:
After you have been staying inside vehicle quietly (eg. sleeping) with vehicle
engine stopping, you want to see the backup image but only put your
vehicle key on the ACC -ON position (no starting the engine), there will have
no image on the monitor after touching the starting button.
So you have to give the vehicle a light vibration (such as re-open and shut
vehicle door, or tap somewhere lightly), then touch
“
Touch for Rearview
”
button to start work.
If you want the RearVision WSU43 to keep working after 30 seconds (for
example, you cannot finish reversing your vehicle during 30 seconds), you
have to touch the
“
Touch for Rearview
”
button on the monitor or
the
cigarette lighter adapter
for another 30 seconds.
*
*
6
05.
OPERATION
04.
MONITOR MOUNT
1. Two way to mount the monitor
1) Stick on the dash board: Fix holder bracket A
(see figur 1) to the install position of monitor via
screw tool, choose and clean a right place on the
dash board, tear the paper of the monitor holder’s
sticky tape, put and press the holder on the dash
board.
2) Socket on the window shield: Fix holder bracket B
(see figur 2) to the monitor via screw tool, choose
and clean a right place on the window shield. With
the suction lever in the released position, press the
suction cup against the windshield. Press the suction
lever toward the suction cup to lock the mount.
To adjust the angle of monitor, loosen the collar on
the ball joint, retighten in the desired position.
06.
BUTTON & SETTING
Function of the monitor backup buttons
1.
The middle button
:
Short Press to enter monitor menu setting.
Long Press (press and hold for 3 seconds) to confirm the chosen
item in the menu setting interface.
BUTTONS
5
Figure 2
Touch
for rearview
Figure 1
Touch
for rearview
2. Plug the monitor cigarette lighter, then socket power cord into a
12-volt DC power port.
Figure 1
Figure 2
