39
If the control lever comes back to the neutral position while it is
traveling down the slope, the machine will automatically stop.
If the machine slides while traveling up on the slope, use the pulling
power of the boom to help the machine clime up the slope.
If engine stops accidentally while traveling down the slope, set the
control lever back to the neutral position to stop the machine, lower the
bucket to the ground to block the machine and then restart the machine.
5)
If the excavator can’t travel for getting into miriness, you can extend arm and place bucket
to ground to lift one side of crawler, then turn the lifted crawler to clean out the bedload. In
order to reduce the force enduring of boom and
arm, the angle between boom and arm should be
in the range of 90
°
--110
°
6)
When the machine gets into wallow or passes
raceway, you can use arm and boom to help the
machine pass.
7)
The machine must travel in the pose shown in fig
3-17 when traveling up on a slope of 15° or
more.
8)
The machine should travel at low speed and in a
pose shown in FIG. 3-18 when it is traveling down
on a slope of 15° or more.
FIG3-16
FIG 3-17
90
0
～
110
0
20
～
30cm
FIG. 3-18
20
～
30cm
90
0
～
