29
Switch to TEST mode, when camera display light up, you can check the configure by key
panel, and switch to “ON “mode, after Red flash for 5 seconds, then the camera will start
to work.
Cautions
: camera display and control panel will be useless when camera at “ON” mode,
you can switch back to “TEST” mode to review the configure.
5. SMS Command Code
This camera support SMS remote control, you can control your camera by sending SMS
code in below:
6. Trouble Shooting
6.1 Camera doesn’t Capture Subject of Interest
1. Check the PIR sensitivity. For warm environmental conditions, set the Sensor Level to
“Low” and for cold weather use, set the sensor for “High”.
Code
Function
Description
*530*
Enable the detection function
Start to work from sleeping mode
*531*
Disable the detection function
Stop to detect the movement of the PIR
*500*
Capture
（
MMS or SMTP
）
Camera takes a picture, then send it to
the configured phone number or E-mail
of mmsconfig
*505*
Capture and get pic (only MMS
mode)
Camera take a picture, then sends it to
phone number which send this SMS
code
*520*
Get Camera information
Camera send a text to phone or email
with pictures quantity, memory card
capacity, battery lever.
