SU-P-015-RevA, 1/5/2021
Page
7
of
7
Figure 13: SyncTrak Diagnosis Tab
j.
Navigate to the Command tab.
k.
In the drop-down menu select "StatusReq" to send a status report to the defined Server IP (or URL) to
confirm device is reporting as expected.
7.
ST4340LC Assembly and Installation
a.
Disconnect the Micro-USB cable from the ST4340LC.
b.
Next, connect the ST4340LC’s back up battery, see Figure 13. Note the Red wire on the connector should
be towards the cable connected end of the device. Tuck the extra length of wire into the device to
prevent pinching during assembly.
Figure 13: Connecting the backup battery
c.
Set the lid back onto the base taking care to not pinch the backup battery wires in the edges of the case.
d.
Insert and tighten the 6 assembly screws provided with the ST4340LC.
Use a PH#1 or PH#2 size
screwdriver or torque driver (1.5 +/- 0.2 in-lbs recommended).
e.
The ST4340LC must be provided with 9v-33v DC power to operate, 12v DC is optimal.
f.
Install the ST4340LC with “THIS SIDE UP” facing towards the sky for best GPS signal reception.
End of Document