Suntec Wellness KLIMATRONIC Heat Screen 1800, Инструкция по эксплуатации

Страница: 14 / 95

Components
(1) Motion sensor
(2) Control keys
(3) Main switch
(4) Air outlet
(5) Feet
Before using it for the first time, please leave the device in operation at full power for about two hours, in order
to eliminate the unpleasant odor. Make sure that the room where the device is located is well ventilated during
this operation. Please do not be worry about the "clicking sounds" during operating the unit for the first time.
This is completely normal and the sounds will disappear.
Operation
Plug the power cord into an outlet that corresponds to the voltage on the rating label of the appliance.
1
. I/0
Press the main switch (
3
) to position "I" to switch into the standby mode.
2
. ON/OFF
Press the "ON / OFF" button (2) to switch into the "LO" mode. Press the "ON / OFF" button (2) again to shut
down the device. The power turns off and the ventilation will turn off 30 seconds later.
3
. Mode
Please press the "MODE" button (2) to switch to "HI" mode. The second time you press it, you can switch to
"AUTO" mode. Here you can set the target temperature between 18°C and 30°C using the "TEMP" key. If the
target temperature is reached, heating is interrupted and only switched on again when the room temperature
is below the set target temperature. The default setting in "AUTO" mode is 24°C.
Please press the "MODE" button (2) again to return to the "LO" mode. The corresponding mode lights up (2).
4.
SENSOR
Press the "SENSOR" button to switch into the "SENSOR" mode. Press the button again to to enter the "normal"
mode. The corresponding mode lights up (2).
The unit turns off if the "SENSOR" does not recognize any motion in the area (
≤
2 m) for 2 minutes.
Once the "SENSOR" perceives a movement in the area ( ≤ 2 m), the unit automatically turns on with a buzzer
sound.
5.
TIMER
Press the "TIMER" button to activate the timer and set the off-time. The maximum is 8 hours. Each level adds
one hour.
6.
LOCK
Press the "LOCK" button for 5 seconds to lock the control panel (2). You can not change any settings now.
Press the "Lock" button again for 5 seconds to reactivate the control panel (2).
7.
WINDOW SENSOR
Please press the "MODE" and "TIMER" buttons simultaneously for 3 seconds to activate the window sensor.
A flashing symbol "[ ]" appears on the display.
As soon as the device detects a temperature drop of 10°C within 30 minutes, e.g. through an open window,
the heating function is interrupted. The unit automatically switches to standby mode and the symbol lights up
continuously on the display.