12
.
DRAINAGE
During the process of cooling, some water will be extracted from the air into the unit. If
the reservoir is full,
both of the compressor and motor will stop. The “water full” sign will
light on, also the machine will beep as reminder.
To make the cooling work again, please empty the water by one of the following ways:
1.
Turn off the air conditioner and avoid
moving it when full.
2. Position a container (a water tray for
example) underneath the drain hole.
3. Remove the drain knob & rubber plug
from the drain hole and allow the
water to drain out.
4.
When the container is almost full,
replace the rubber plug in the drain
hole and empty the water tray.
5.
Repeat until the unit is emptied.
6. Replace the rubber plug and tighten
the drain knob firmly.
7. Switch on the unit - the full water or
compressor operating indicator
should not be flashing.
FIG.14
If you wish to operate the unit without the need to empty the water tank, please:
•
Remove the drain knob and rubber
plug and retain for future use.
•
Connect the drain tube supplied to
the water outlet as shown and locate
the other end into a drain.
FIG.15
