1.3. Safety Instructions
Be sure to read this manual thoroughly before installation.
Do not attempt to install the inverter by yourself. Installation work must be carried out in
compliance with national wiring standards and by suitably qualified personnel only. Do not
turn on the power until all installation work is complete.
Do not disassemble the inverter. If you need repair or maintenance, contact a professional
service centre.
Always use an individual power supply line protected by a circuit breaker and operating on
all wires with a distance between contacts of at least 3mm for this unit.
The unit must be correctly grounded and the supply line must be equipped with a suitable
breaker and RCD to protect people.
Disconnect all wires/cables before performing any maintenance or cleaning to reduce the
risk of electrical shock.
The unit is not explosion-proof, so it should not be installed in an explosive atmosphere.
Never touch electrical components immediately after the power supply has been turned off
since the system can still have residual energy, so electric shock may occur. Therefore, after
turning off the power, always wait 5 minutes before touching electrical components.
This unit contains no user-serviceable parts. Always consult an authorised contractor for
repairs.
HIGH LIFE RISK DUE TO FIRE OR ELECTROCUTION.
The Sunsynk Single-Phase Hybrid Inverter can only be installed by a qualified li-
censed electrical contractor. This is not a DIY product.
1.4. Disposal Remarks
DO NOT dispose this product with domestic waste!
Electrical devices should be disposed of in accordance with regional directives on electronic
and/ or electronic-waste disposal. In case of further questions, please consult your supplier. In
some cases, the supplier can take care of proper disposal.
Page | 6
Hybrid Inverter | Installer Manual
