SunSun 51627, Инструкция по эксплуатации

Страница: 7 / 18

© by WilTec Wildanger Technik GmbH Item 51627
–51633
Page 7
http://www.WilTec.de
http://www.aoyue.eu 06 2021-1
http://www.teichtip.de
Definition:
Clear water
We speak of clear water when you see the fish and pond bottom at a depth of 1 m.
Installing the filter
1. Install the filter so that it is protected against flooding and cannot fall into the pond. It should
therefore be placed at a minimum distance of 2 m from the pond.
2. Dig a hole near the pond and appropriately fix the filter.
3. Make sure that the cover of the filter can be opened.
4. With a lifting height of more than 1 m being required, you should perhaps use a more powerful
pump.
Hose connection
We recommend that you heat up the hose with warm water before attaching it to the stepped hose tail
and fixing it with a hose clamp; thus, it cannot come off.
•
Use a hose with the largest possible diameter.
•
With hoses longer than 4 m, it is advisable to use a hose tail with the largest possible diameter.
•
To minimise pressure losses, cut off the parts of the stepped hose tail that you do not need.
Cleaning outlet
You can direct the dirty water directly to the sewers or a flowerbed.
Operating the pressure filter
Before operating the pressure filter, always check gaskets, connections, and clamps for correct assem-
bly. Adjust the switch to the
“filter” position. Do not fail to familiarise yourself with the safety regulations
before commissioning.
•
Switch on the pump.
Attention! Never operate the UV lamp without water flowing past it.
•
Check the connections for possible leaks.
•
Connect the device to the power supply.
•
The filter system with integrated UV lamp must operate 24/7.
•
Replace the UV lamp after 8,000 hours of operation in order that the device keeps its highest
efficiency.
•
The filter sponge must regularly be cleaned.