Sunstream BOAT LIFTS FL13018, Сборка и инструкция по установке

Страница: 22 / 33

ZINC, 5.25" LONG, CMT 21, FLOATLIFT
SOCKET HEAD CAP SCREW, 1/4"-20 X 1.125
NUT, .250 - 20, SS
To ward off galvanic corrosion, it is essential that “sacrificial” zinc(s) are installed and maintained on
your lift. Zinc is used as it has a higher voltage in water so the current will be more inclined to flow
from it. The zinc becomes the corroding anode, while the lift serves as the cathode and is protected
from corrosion.
It is imperative that you replace the zinc on your lift regularly . Because many external factors
affect the rate at which a zinc deteriorates, Sunstream recommends that you check its condition
frequently, and change the zinc every six months or more often if needed. Zincs on lifts in coastal
areas near the ocean deteriorate more rapidly and need to be changed more frequently.
Effects of galvanic corrosion are not covered by your Sunstream warranty. Not maintaining
zincs on the lift constitutes abuse and voids the Sunstream warranty.
Protect your investment with the proper steps . To complete the electrical circuit, the zincs must
be connected to the lift as shown below. Sunstream would be pleased to provide zinc replacement
services; simply call to schedule. If replacing your own, Sunstream recommends using high-quality
zincs that are available through the Sunstream service department.
6X
FORM NO. PAGE 22 OF 33 REV. 690190
C-01