Page 9
INSTALLATION AND ASSEMBLY – Reversible Door Swing
FIGURE 1 (Normal position)
FIGURE 2 (Position after door reversal)
Top Hinge ---------1
Screw (3) ----------2
Door----------------3
Bottom Hinge----4
Screw (3) ----------5
Frame--------------6
Hole Cover--------7
This refrigerator can be opened either from the left or right side. The default way of opening the door is from
the right side. If you want to open the door from the left side, please follow the instructions below. Refer to
figures 1 and 2 on the following page.
NOTE: All the removed parts must be well kept for the reinstallation of the door
1. Remove the three screws (5) that hold the lower door hinge (4), keep the hinge for later use.
2. Remove the door from the upper pin, and keep the padded surface upwards to prevent scratching.
3. Remove the upper hinge cover (1), remove the two screws (2), and hold the upper hinge (1), save the
hinge for later use.
4. Remove the cover (7) and transfer it to the same location on the opposite side.
5. Insert the lower door hinge in the right side, fix the lower right hinge
by tightening all the screws.
6. Remove the pin cap (9) from the right side of the upper frame of the
door, and then transfer it to the same location on the opposite side.
7. Put the door on the Lower Door Hinge(5), keep the door level , and
then fix the upper hinge(3) to the body(4) by the screws
8. Put on the upper hinge cover (1).