Sunstech RPBT450, Инструкция по эксплуатации

Страница: 4 / 33

Remote Control CHARGING THE BLUETOOTH DEVICE
PAIRING/RECONNECTING THE DEVICE
01. CBO Repeat
02. Power On/Off
03. Equalizer
04. Volume Up
05. Volume Down
06. Pause/Play
07. A-B Repeat
08. FM Scan
09. Input
10. Last Track
11. Next Track
12. Numeric Pad
1.Connect the speaker’s Micro USB socket with the power source’s USB port through USB cable.
(Micro USB port is located on the back of the device)
2.The power indicator will show red while the battery is charging. When the speaker has reached a full
charge the LED indicator will turn off to indicate the battery is fully charged;
3.Disconnect the USB cable when it is fully charged.(A full charge will take approximately 6 hours)
1.Power the speaker on, when power on P30 will automatically enter the last input mode. You can access
Bluetooth mode by pressing the input button to cycle through available input modes.
2.Now, turn on the Bluetooth function of your device.
3.Search for “RPBT450” and select it to begin Bluetooth pairing, this is for the first time pairing or pairing
a new mobile device.
4.The speaker will reconnect automatically if your mobile phone has been paired previously.(Note:
depending on the device’s type and configuration, manual reconnection may be require each time the
speaker is used.)
5.If pairing is successful, speaker will make a tone to confirm.
6.Slide the power switch to the “off” position to turn the unit off when finished.(Note: If you can not
search for the Speaker, this means the last device is reconnecting automatically. Choose to forget the
speaker from your Bluetooth menu and try to pair with the speaker again.)
05 06