EN-9
EN-10
Insert a CD,MP3, CD-R.
No CD/MP3 inserted
CD/MP3
/
USB playback does not work
CD/MP3
/
USB badly scratched/dirty
Replace/clean CD/MP3
/
USB
(see maintenance)
The CD/MP3 skips tracks
CD/MP3 damaged or dirty
Replace or clean CD/MP3
- CD
-
R
、
is
blank
or
the
disc
is
not
finalized
Use
a
finalized
CD
-
R
.
TECHNICAL
SPECIFICATIONS
GENERAL
Power Requirement ......................................................................................AC :110/220V~50/60Hz
Power consumption .......................................................................................................AC 13.5
Watts
Dimensions.....................................................................Appro
.
215x mm(L)208x mm(W) 113x mm(H)
Operation temperature....................................................................................................+5
℃
- +35
℃
RECEIVER SECTION
Receiving Bands.........................................................................................................................FM
ST
.
Tuning Range........................................................................................................... FM:87.5-108MHz
COMPACT DISC SECTION
Optical Pickup....................................................................................................... .3-Beam Laser
Frequency Response............................................................................................100Hz - 16KH z
AUDIO SECTION
Power output ....................................................................................................Maximum 1 Watt x 2
Headphone Impedance .....................................................................................4 ~ 32 Ohms
ACCESSORIES
Instruction Booklet.................................................................................................1
Ac line cord................................................................................................................1
-Power cord not securely conneted
No disc indication
Connect the AC POWER cord properly
TROUBLESHOOTING
Troubleshooting
If a fault occurs,first check the points listed below before taking the set for repair.
Do not open the set as there is a risk of electric shock.
If you are unable to remedy a problem by following these hints,consult your dealer or service
center.
WARNING:
Under no circumstances should you try to repair the set yourself,as
this will invalidate the warranty.
-Problem
·
Solution
No sound /power
-Volume not adjusted
·
Adjust the VOLUME
-Batteries dead/incorrectly inserted
·
Insert(fresh)batteries correctly
Display does not function properly/NO
reaction to operation of any of the controls
-Electrostatic discharge
·
after a few seconds
Switch off and unplug the set.Reconnect
-CD badly scratched or dirty
·
Replace/ clean CD.see Maintenance
-Laser lens steamed up
·
temperature
Wait until lens has adjusted to room
-Program is active
·
Quit Program mode(s)
Environmental information
We have done our best to reduce the packaging and make it easy to separate into 3 materials:
cardboard,paper pulp and expandable polyethylene.
Your set consists of materials which can be recycled if disassembled by a specialized company.
Please observe the local regulations regarding the disposal of packaging,dead batteries and
old equipment.
