WARNING
Shock hazard.
Be sure AC power is not connected
before performing this procedure.
3
Slip the Body Fan into
the Body Fan Endcap,
as shown. Be sure to
insert the wire connector
into the rectangular hole
and route the wire in the
groove in the Body Fan
Bracket.
Removed from unit
2
Remove the two screws shown
and use them to attach the Body
Fan Mounting Bracket in the same
holes the screws came out of.
Install #10 x 1/2” screws in the
upper two holes of the bracket.
In this kit you should find the following parts:
SUPPORT RAILS
(under acrylic)
Before beginning this procedure... If your bench has four support rails under the bench acrylic, read this sheet.
If your bench has three rails, read the other sheet. You will need a #2 Phillips screwdriver to perform this procedure.
(4) - #10 x 1/2” Phillips pan head
sheet metal screws
(2) - 1/4-20 x 1/2” Phillips pan head
machine screws with lock washer
Body Fan
Mounting Bracket
Body Fan
Body Fan
Endcap
1
Open the bench acrylic shield and
remove the Foot End Bench Endcap
by removing the four screws that
hold it in place. Save these screws
to install the new endcap.
pg. 3
24735-02A
Installing the Body Fan on a SUNSTAR ZX32
(With 4 Support Rails)
