C. REPLACE THE FACEPLATE
Snap the faceplate back onto the front
of the stereo.
CONNECT THE WIRING
Included in the Stereo Installation Kit are three wire harnesses, two for the
speakers and one for the Stereo Power Supply. You will also use the wiring
harness supplied with the stereo. Plug the stereo wiring harness into the back
of the stereo. Connect the other three wire harnesses to it as described in the
illustration below. Connect the wires with wire nuts. There will be (6) wires on the
stereo wiring harness not used which should be cut off close to the connector.
Plug in the antenna, included with the Stereo Installation Kit.
D. ATTACH THE MOUNTING BRACKET
Slide the stereo into the mounting bracket
as shown. Secure it in place with four
screws supplied with the stereo. Use the
ones with rounded heads as shown in the
illustration below.
B. REMOVE THE MOUNTING SLEEVE
Slide the two pullers straight into the slots
on both sides of the stereo until they click.
Pull the mounting sleeve off of the stereo
and discard.
A. REMOVE THE FACEPLATE
Using the small wire tool, carefully pull
the face plate off. Simply hook one of the
notches and pull up and out, as shown.
Do the same at all four notches to release
the faceplate.
Grey
Grey/Black
White
White/Black
Black
Red
Antenna
Fuse
To Left
Speaker
To Right
Speaker
Striped or Ribbed Wire
Striped or Ribbed Wire
Wiring Harness
with Stereo
To Power
Supply
Back of Stereo
Black
Red
Wire
Nut
Reinstall the Gas Spring Cover Panel with the
same screws taken out earlier. Slide the stereo
assembly into the slot in the Gas Spring Cover
Panel and secure in place with four #10x1/2”
screws with blue heads.
RED WIRE
POWER SUPPLY
8
9
10
11
BLACK WIRE
Place the Power Supply on the Power Supply Bracket. Plug
its power cord into it and into a 110V wall receptacle. Plug
the two-prong wire harness, from the stereo, into the Power
Supply. A label has been supplied with this kit to remind you
how to connect the two-prong plug. Apply it on top of the
Power Supply, directly over the connection. Connect the
speaker wires to the speakers. Turn the Power Supply on.
