![SunStar KM-76 Скачать руководство пользователя страница 10](http://html.mh-extra.com/html/sunstar/km-76/km-76_user-manual_1400318010.webp)
10
①
③
⑤
⑥
④
⑦
A
②
The machine has been adjusted prior to delivery. However, check rotation direction, number of rotation, and lubrication before
repeating the following adjustment and performing desired skiving.
Adjustment
4
1) Presser foot
(1) Push the presser bar lifter
①
down.
(2) Insert the presser foot control screw
②
, and determine
the desired distance(A) between the presser foot
⑦
and
the knife
⑧
, as in Figure 4.
A. Narrow (small) Cutting
Turn control screw
②
counterclockwise to lower the
presser foot after determining an adequate cutting
width for the material.
B. Wide (large) Cutting
Turn control screw
②
clockwise to lift the presser
foot. Measure the distance(A) from the left hand
side of the machine.
[Figure 3]
⑧
(3) Cutting side-ways (Figure 5)
Turn control screw
③
clockwise or counterclockwise to
get the desired angle of the presser foot.
(4) Cutting with shapes
Switch the presser foot to desired shape, such as stripe or
sandpaper.
(5) Removing the presser foot
Lift the presser bar lifter up, dismount the presser foot
spring
④
horizontally, loosen the presser foot tension
screw
⑤
, and take the loop
⑥
out, which will allow you
to remove the presser foot and the fixation pin. (1 set
includes 4 presser foots )
Note) When replacing the presser foot, lift the presser foot up with the presser foot control screw
②
before pushing the
presser bar lifter
①
down. Be careful with the presser foot because it may scratch the feeding roller if it is not lifted up to
a certain level. Now loosen the screw
⑤
and remove the loop from the back, which will allow you to dismount the
presser foot and the fixation pin (Refer to Figure 3).
[Figure 4]
[Figure 5]