- 4 -
■
THREADING
Your sewing machine comes with properly placed threads. Therefore,
the easiest and simplest way to re-threading is to tie the thread that
comes with the machine, with a new one. Check if the knotted area of
the old and new threads goes through the needle hole smoothly.
CAUTION
Pull the thread 100mm out from the needle hole when starting
the sewing. If you need to replace the threads completely, refer
to the threading table and Figure 4.
[ Fig. 4 ]
■
BOBBIN WINDER
The bobbin winder comes with the sewing machine and is used to
wind the thread on the bobbin.
a) Place the bobbin on the bobbin winder shaft. Place the thread to
move between the thread hole and the tension disk.
b) Turn the bobbin in a clockwise direction several times to make the
threading easier.
c) Press the latch (
③
, Figure 5), then the wheel of the bobbin winder
will come in contact with the belt. Run the machine until the wheel
of the bobbin winder automatically removes itself from the belt. At
this point, the thread is wound on the bobbin completely.
Threads can be wound tightly or loosely depending on the type of
threads used. Adjust the thread tension by turning the index screw
(
②
, Figure 5).
[ Fig. 5 ]
Pulley
Adjusting screw
Latch
Tension
disk
②
①
③
■
HOW TO THREAD THE BOBBIN CASE
Insert the bobbin case in the bobbin frame. Firmly fix the bobbin in
the frame, push the thread through the hole and pull it into the lower
part of the tension spring and the hole.
[ Fig. 6 ]
■
HOW TO PLACE THE BOBBIN CASE
Turn the pulley until the needle bar comes to its highest position.
Bring the bobbin case towards the center stud in the bottom of the
bobbin case. Press the bobbin case until it makes a clicking sound in
the frame. Follow the instructions carefully to protect the needle in the
bobbin frame.
[ Fig. 7 ]
■
HOW TO PULL THE THREAD FROM THE BOBBIN
Hold the end of the thread and turn the pulley towards machine turning until the needle starts to move up and down again. Pull the
thread lightly so that the thread in the bobbin passes up through the needle hole. Place two strands of threads under the presser foot
when you begin to sew.
■
SEWING
Before and after seaming, always turn the pulley to move the thread take-up lever to its highest position. Otherwise, threads can get
tangled or come out from the needle hole during sewing. If the thread take-up lever is at the highest stroke, you do not necessarily
have to hold on to both threads.
Содержание DPK-2
Страница 7: ... 7 TABLE DRAWING ...
