Sunshine T1P1, Руководство по эксплуатации, Страница: 16 / 20

16
-
20
Fig.5 Fig.6 Fig.7
2-4.4 Wiring and alarm
Warning !!To prevent chance of serious injury, death or property damage,
disconnect the product from main power supply before working on it.
Install a fuse between the power supply and the product is strongly recommended!
The electrical circuit diagram of the lubrication unit is affixed inside the unit and can
be accessed by removing the cap.
Remove the cap (Fig.5)and inside you can see terminal plate and cable gland nut.
Loosen cable gland(Fig.6) and then insert cable through the cable gland hole(Fig.7)to wire
up. Fix the cable gland to the housing.
Wiring must comply with the electrical circuit diagram (Fig.8) of the lubrication unit
affixed inside the unit.Otherwise, property damage or serious injury can occur.
Level switch and pressure switch are strongly recommended to assemble for fault
monitoring and preventing chance of property damage or serious injury. In the model
design with a control unit, the electrical connection to the monitoring units such a spressure
switches and float switches is establis hedinside the lubrication unit directly to the
connectorson the electronic control unit. Depending on the control unit's model design, a
signal line for fault monitoring can be run outwards to connect to the machine control unit
via a cable fitting mounted on the lubrication unit.
The lubrication unit is design to be controlled by the control unit of the machine. Wire
up in accord with the electrical circuit diagram (Fig.8).
After the electrical connection is finished, tighten the cable gland (Fig.9) and fix the
cover. Then turn on the power and the power indicator on the panel for YET-T will lamp if
the electrical connection is correct.