10. Find and Unbind a Zigbee Lighting Device
11. Clear All Find and Bind Mode Paired Lighting Devices
12. Setup a Network & Add Devices to the Network (No Coordinator or Hub Required)
Step 5
: Add more remotes to the network as you would like
.
Step 6
: Factory reset the lighting devices that you would like to add to the network, refer to their manuals
.
Step 7
: Touchlink to pair the added remotes and lighting devices you would like to add, the devices will be added
to the network through Touchlink, refer to their manuals
.
14. How to Check Whether the Remote Belongs to a Network or not
Short press any other buttons except group buttons, indicator blinking means the remote has already been
added to a network, no blinking of indicator means the remote does not belong to any network.
Wiring diagram
AC 100-240V
AC Power
50/60Hz
ZigBee Controller
L
N
Installation
LED indicator
Step 1
: Start find and bind mode on
the Zigbee lighting device (initiator
node) and enable it to find and bind
target, refer to its manual
.
ZigBee Lighting Device
Step 2
: Press and hold down until
LED indicator turns on
.
Step 3
: Short press twice to enable
the remote (target node) to find and
unbind initiator. LED indicator
flashes 4 times for successful
unbinding or twice if unbinding fails.
LED indicator
Step 1
: Press and hold down until
LED indicator turns on
.
Step 2
: Short press 5 times
continuously to clear all bound
lighting devices . LED indicator
flashes 4 times for successful
unbinding.
LED indicator
Step 1
: Factory reset the remote
and the lighting device
,
refer to
their manuals
.
ZigBee Lighting Device
< 10cm
Step 2
: TouchLink the remote and
device to setup a network, refer to
their manuals
.
Step 3
: Short press button to
enable the network to discover and
add devices, LED indicator will
flash twice. 180 seconds timeout,
repeat the operation
.
Step 4
: Set another remote into
network pairing mode and pair it to
the network, refer to its manual
.
13. OTA
The remote supports firmware updating through OTA, and will acquire new firmware from zigbee controller or
hub every 10 minutes automatically.