Note : only can pair with
CCT color lighting. only can pair with LED RGB color lighting.
LED
Installation
12
-2
4V
D
C
P
ow
er S
up
ply
DC version needs connect
with DC power supply
Pair with RF receiver
Step 2:
Choose and click a zone number(
e.g.
RGB color zone
2
)
Step 1:
Click the “
Learning Key
” button on RF receiver or re-power on the
receiver three times continuously to set it into pairing status
Learning
Key
RF LED Receiver
Step 3:
Touch the slider, LED lights connected with the RF receiver flicker
once means the receiver is paired with
RGB color zone
2
successfully.
Built-in 10 color changing modes are as follows:
Mode 1: Any two colors of RGB mix fade-in & fade-out
Mode 2: RGB three colors mix fade-in & fade-out
Mode 3: RGB three colors mix fade-out & fade-in
Mode 4: RGB flash
Mode 5: RGB three colors fade-in & fade-out successively
Mode 6: RGB three colors fade-in successively
Mode 7: RGB three colors fade-out successively
Mode 8: RGB three colors jump changing successively
Mode 9: R&B two colors mix fade (R in B out), then G fade-in, then R&B mix fade (R out B in), then G fade-out
Mode 10: B fade-out, then G&B mix fade (G out B in), then R&G mix fade (R out G in), then R fade-in
Click the paired zone number/numbers, then touch the slider or the other buttons to do the controlling
Operate the remote after pairing
1. Do wiring the wall panel & RF receiver according to wiring diagram (please refer to the instruction of RF receiver that
you would like to pair with)
2. Power on, then touch the button to turn on the controller, indicator of the controller turned blue
Operation
