Receiver for RGBW Remote & Wifi transmitter
Work with different sender
Work with WIFI transmitter
Model: SR-1009DIN
Parameter
Part No.
Input Voltage
Remarks
Current
SR-1009DIN
12-36VDC
Constant voltage
4x(60-180)W
4x5A
Output
Product Size
Control RGBW, RGB, CC-CW, Single color LED lighting.
Wiring diagram
Operation
Learning (matching)
a. Do wiring according to connection diagram
b. Wake up the remote control by touching ON/OFF button.
c. Press learning button on receiver.
d. Touch any zone button on remote control.
e. Then touch color wheel.
f. Connected LED light will blink to confirm zone designation.
g. Press at learning button on receiver over 5 seconds until LED light flash, then delete the learned ID.
98.0
65.0
105.5
53.0
Power Supply
12-36VDC
L
N
1
10V
-230V
AC
SR-1009DIN
LED Controller
V-
V+
+
R-/1
G-/2
B-/3
W-/4
Power input
Learning key
RGB/W or CDW LED strip
Note 1: To choose a master from slaves by jumper for each zone.
Short circuit for master.
Open circuit for slave.
Each zone only can set one master controller. After a period of time, the master will do synchronization
operation to keep the same color or mode of all slaves in one zone.
Note 2: Each remote control 8 zones (areas) receivers, each area can be learned as many receivers as
we can.
Each receiver maximally can be controlled by 8 different remote controllers.
