www.sunred.nl
Installation
·
Drill 4 holes positioning as shown above. Insert Part 4 (4 PCs totally) to the wholes respectively. Align Part 2 to the hole
then fix it with provided screws (Part 3).
·
Insert Part 2 into the hole (Section A) of Part 1. Fix them
·
Plug in the unit to a socket. Make sure the power supply is same as rated. When press the "On" button for the heater on the
control panel, the blue indicator light for the heater is flash
·
Press button "On" for the heater on the control panel or the remote controller to switch on the heater. Then the blue indicat
light for the heater is on.
·
To switch off the heater, press the button "Off" on the con
panel of the heater, the blue indicator light is off, and the remote control is not functional for the heater. To press "Off"
the heater on the remote control will only swift t
flashing.
CAUTIONS
·
The unit must be placed with the clearance of 100cm to the wall and 30cm to the ceiling .
·
The heater must be installed at least 1,8m above the floor.
·
The unit must be securely placed on a horizontal and flat surface.
·
The unit is at high temperature during operation. It keeps hot for a period after shut down. Potential danger would occur whe
touching it during this period.
·
Don't place the unit close to curtain and/or other flammable objects.
·
Don’t' cover the unit with anything during operation or a short time after it's shut down.
·
Don't wrap the power supply cord on the unit.
·
The unit must be handled with care, and avoid of vibration or hitting.
·
The unit must be securely grounded during operation.
·
When damaged, the unit must be repaired by professional repairing team.
·
If the supply cord is damaged, it must be replaced by t
to avoid a hazard.
·
The heater must not be located immediately below a socket
·
When assembling, keep clear from any board or flammable material.
·
Do not use this heater with a programmer, timer or any other device that switches the heater on automatically, since a fire risk
exists if the heater is covered or positioned incorrectly.
·
This appliance is not intended for use by persons (including children) with reduced physical, sens
lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by
a person responsible for their safety.
·
Children should be supervised to ensure that they do not play
·
The unit is for household use only. It's not allowed to use in building site, greenhouses, barn or stable where there's flamm
dust.
·
The head of the unit is at high temperature during operation. Unplug the unit and wait till it's co
·
Don't use this heater in the immediate surroundings of a bath, a shower or a swimming pool.
·
Don't use this unit in place where causticity or volatile air exists, i.e. dust, steam, gas, etc.
·
Don't use this unit as a cloth drier or towel drier.
·
Don’t' use this unit as a sauna heater.
·
Don't use this unit as a room heater of heat storing.
·
Don't use this unit in place of animal propagating and raising.
·
Don't use this unit in heating system of hot air center.
·
The unit should be plugged in a socket, which is easily visible and reachable.
·
Two Dark points may exist on the surface of the heating elements, or the surface of the heating element may turn white during
the first few minutes after it's turned on. This is normal, and may not affect th
www.sunred.nl
Drill 4 holes positioning as shown above. Insert Part 4 (4 PCs totally) to the wholes respectively. Align Part 2 to the hole
) of Part 1. Fix them with the provided screw (Part 5).
lug in the unit to a socket. Make sure the power supply is same as rated. When press the "On" button for the heater on the
control panel, the blue indicator light for the heater is flashing, which means it's in standby status.
Press button "On" for the heater on the control panel or the remote controller to switch on the heater. Then the blue indicat
To switch off the heater, press the button "Off" on the control panel of the heater. When press the "Off" button on the control
panel of the heater, the blue indicator light is off, and the remote control is not functional for the heater. To press "Off"
the heater on the remote control will only swift the appliance into standby status, and the blue indicator light for the heater is
The unit must be placed with the clearance of 100cm to the wall and 30cm to the ceiling .
The heater must be installed at least 1,8m above the floor.
The unit must be securely placed on a horizontal and flat surface.
The unit is at high temperature during operation. It keeps hot for a period after shut down. Potential danger would occur whe
Don't place the unit close to curtain and/or other flammable objects. Othterwise there will be a danger of catching fire.
Don’t' cover the unit with anything during operation or a short time after it's shut down.
nit.
The unit must be handled with care, and avoid of vibration or hitting.
The unit must be securely grounded during operation.
When damaged, the unit must be repaired by professional repairing team.
If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order
The heater must not be located immediately below a socket-outlet.
When assembling, keep clear from any board or flammable material.
programmer, timer or any other device that switches the heater on automatically, since a fire risk
exists if the heater is covered or positioned incorrectly.
This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or
lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by
Children should be supervised to ensure that they do not play with the appliance.
The unit is for household use only. It's not allowed to use in building site, greenhouses, barn or stable where there's flamm
The head of the unit is at high temperature during operation. Unplug the unit and wait till it's cool before cleaning.
Don't use this heater in the immediate surroundings of a bath, a shower or a swimming pool.
Don't use this unit in place where causticity or volatile air exists, i.e. dust, steam, gas, etc.
drier.
Don't use this unit as a room heater of heat storing.
Don't use this unit in place of animal propagating and raising.
Don't use this unit in heating system of hot air center.
socket, which is easily visible and reachable.
Two Dark points may exist on the surface of the heating elements, or the surface of the heating element may turn white during
the first few minutes after it's turned on. This is normal, and may not affect the performance of the unit
Drill 4 holes positioning as shown above. Insert Part 4 (4 PCs totally) to the wholes respectively. Align Part 2 to the holes, and
lug in the unit to a socket. Make sure the power supply is same as rated. When press the "On" button for the heater on the
Press button "On" for the heater on the control panel or the remote controller to switch on the heater. Then the blue indicator
trol panel of the heater. When press the "Off" button on the control
panel of the heater, the blue indicator light is off, and the remote control is not functional for the heater. To press "Off" button for
he appliance into standby status, and the blue indicator light for the heater is
The unit is at high temperature during operation. It keeps hot for a period after shut down. Potential danger would occur when
terwise there will be a danger of catching fire.
he manufacturer, its service agent or similarly qualified persons in order
programmer, timer or any other device that switches the heater on automatically, since a fire risk
ory or mental capabilities, or
lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by
The unit is for household use only. It's not allowed to use in building site, greenhouses, barn or stable where there's flammable
ol before cleaning.
Two Dark points may exist on the surface of the heating elements, or the surface of the heating element may turn white during
e performance of the unit
