![Sunred HEXAGONAL GLASS HEXB Скачать руководство пользователя страница 6](http://html1.mh-extra.com/html/sunred/hexagonal-glass-hexb/hexagonal-glass-hexb_manual_1399173006.webp)
www.sunred.nl
CAUTION
PLEASE READ CAREFULLY THE FOLLOWING SAFETY GUIDELINES BEFORE OPERATION
-
Installation and repair should be done by a qualified service person.
-
Improper installation, adjustment, alteration can cause personal injury or property damage.
-
Do not attempt to alter the unit in any manner.
-
This appliance must be installed and the gas cylinder stored in accordance with the regulation in force.
-
Do not move the appliance when in operation.
-
Shut off the valve at the gas cylinder or the regulator before moving the appliance.
-
The tubing or the flexible hose must be changed every year.
-
In case of violent wind particular attention must be taken against tilting of the appliance.
-
Do not store or use gasoline or other flammable vapors or liquids into the heater unit.
-
The whole gas system, hose regulator, pilot or burner should be inspected for leaks or damages before use.
-
All leak tests should be done with a soap solution. Never use an open flame to check for leaks.
-
Do not use the heater until all connections have been leak tested.
-
Turn off immediately the gas valve if smell of gas is detected.
-
Do not transport the heater while it’s operating.
-
Do not move the heater after it has been turned off until the temperature has cooled down.
-
Keep the ventilation opening of the cylinder enclosure free and clear of debris.
-
Do not paint radiant screen, control panel or top canopy reflector.
-
Control compartment, burner and circulation air passageways of the heater must be kept clean.
-
Frequent cleaning may be required as necessary.
-
The gas cylinder should be turned off when the heater is not in use.
-
Check the heater immediately if any of the following exists:
-
The heater does not reach temperature.
-
The burner makes popping noise during use (a slight noise is normal when the burner is extinguished).
-
Smell of gas in conjunction with extreme yellow tipping of the burner flames.
-
The LP regulator/hose assembly must be located out of pathways where people may trip over it or in area
where the hose will not subject to accidental damage.
-
Any guard or other protective device removed for servicing the heater must be replaced before operating the
heater.
-
Change the gas cylinder in a well ventilated area, away from any inflammation source.
-
Check that the regulator seal is fitted and that it is in good condition.
-
Do not obstruct the ventilation holes of cylinder housing.
-
Adults and children should stay away from high temperature surfaces to avoid burns or clothing ignition.
-
Children should be carefully supervised when they are in the area of the heater.
-
Clothing or other flammable materials should NOT be hung on the heater or placed on or near the heater.
-
User may replace the rubber hose by himself and note the length of the hose is 60cm and the hose must be
required by the national conditions.
-
LP Characteristics-Flammable, explosive, heavier than air-settles in low areas.
-
In its natural state, propane has no odor. For your safety, an odorant is added that smells like rotten cabbage.
Содержание HEXAGONAL GLASS HEXB
