Sunred Flame Torch, Руководство пользователя

Страница: 4 / 64

- 4 -
PLEASE READ CAREFULLY THE FOLLOWING SAFETY GUIDELINES BEFORE OPERATION

Installation and repair should be done by a qualified service person.

Improper installation, adjustment, alteration can cause personal injury or property damage.

Do not attempt to alter the unit in any manner.

This appliance must be installed and the gas cylinder stored in accordance with the regulation in force.

Do not move the appliance when in operation.

Shut off the valve at the gas cylinder or the regulator before moving the appliance.

The tubing or the flexible hose must be changed every year.

In case of violent wind particular attention must be taken against tilting of the appliance.

Do not store or use gasoline or other flammable vapors or liquids into the heater unit.

The whole gas system, hose regulator, pilot or burner should be inspected for leaks or damages before use.

All leak tests should be done with a soap solution. Never use an open flame to check for leaks.

Do not use the heater until all connections have been leak tested.

Turn off immediately the gas valve if smell of gas is detected.

Do not transport the heater while it’s operating.

Do not move the heater after it has been turned off until the temperature has cooled down.

Keep the ventilation opening of the cylinder enclosure free and clear of debris.

Do not paint radiant screen, control panel or top canopy reflector.

Control compartment, burner and circulation air passageways of the heater must be kept clean.

Frequent cleaning may be required as necessary.

The LP tank should be turned off when the heater is not in use.

Check the heater immediately if any of the following exists:
-
The heater does not reach temperature.
-
The burner makes popping noise during use (a slight noise is normal when the
burner is extinguished).
-
Smell of gas in conjunction with extreme yellow tipping of the burner flames.

The LP regulator/hose assembly must be located out of pathways where people may trip over it or in area
where the hose will not subject to accidental damage.

Any guard or other protective device removed for servicing the heater must be replaced before operating the
heater.

Change the gas cylinder in a well ventilated area, away from any inflammation source.

Check that the regulator seal is fitted and that is in good condition.

Do not obstruct the ventilation holes of cylinder housing.

Adults and children should stay away from high temperature surfaces to avoid burns or clothing ignition.

Children should be carefully supervised when they are in the area of the heater.

Use may replace the rubber hose by himself and note the length of the hose is 60cm. And the hose must be
required by the national conditions.

LP Characteristics-Flammable, explosive, heavier than air-settles in low areas.

In its natural state, propane has no odor. For your safety, an odorant is added that smells like rotten cabbage.

Contact with liquid LP can cause freeze burns to skin.

This heater is shipped from the factory for Propane, Butane and their mixture (commonly called LPG) use only

Use only 10kg(Dia. can not exceed 31cm & Height can not exceed 66cm) LP gas cylinders conforms to local
regulation in force (same as commonly used on gas grills) with safety valves.

When heater is not in use, turn Control Valve OFF. Close the valve of the gas cylinder or the regulator after use.

The use of this appliance in enclosed areas can be dangerous and is “PROHIBITED”