Sunred Flame Torch Black, Руководство пользователя

Страница: 7 / 58

www.sunred.nl
ANY GAS ODOR IS YOUR SIGNAL TO GO INTO IMMEDIATE ACTION!
o
Do not take any action that could ignite the fuel gas.
o
Do not operate any electrical switches.
o
Do not pull any power supply or extension cords.
o
Do not light matches or any other source of flame.
o
Do not use your telephone.
o
Get everyone out of the building and away from the area immediately.
o
Propane (LP) gas is heavier than air and may settle in low areas. When you have reason to suspect a
propane leak, keep out of all low areas.
Contact fuel gas supplier and your fire department. Do not re-enter the building or area.
Stay out of the building and away from the area until declared safe by the fire-fighters and your fuel gas supplier.
FINALLY, let the fuel gas service person and the fire-fighters check for escaped gas. Have them air out the building
and area before you return. Properly trained service people must repair any leaks, check for further leakages, and
then relight the appliance for you.
LEAKAGE TEST
Gas connections on the heater are leak tested at the factory prior to shipment. A complete gas
tightness check must be performed at the installation site due to possible mishandling in shipment or excessive
pressure being applied to the heater. The heater must be checked with a full cylinder. Make sure the safety control
valve is in the OFF position.
Make a soap solution of one part liquid detergent and one part water. The soap solution can
be applied with a spray bottle, brush or rag. Soap bubbles will appear in case of a leak.
Leakage test points. See pictures below.
Turn the gas supply ON.
In case of a leak, turn off the gas supply. Tighten any leaking fittings, then turn the gas supply
on and recheck. Contact your dealer for assistance if bubbles continue to appear.
Never leak test while smoking.