1
2
3
4
5
Concrete
Pad
Level
G
H
B
L
I
I
Where To Place the Solar Light
Place the solar light in an area where it will
receive direct sunlight for at least 8 hours
per day. The number of hours the light is
illuminated is directly proportional to the number
of hours of sunlight it receives. If the light is
placed in a shaded area, it will not be able to fully
charge and its burn time will be limited. Do not
place the light near other outdoor lighting like
porch or streetlights. These may fool the sensor
and keep the light from coming on, or cause it to
turn off automatically.
Allow lantern to charge for at least 8 hours in full
sunlight with the ON/OFF switch in the OFF position.
Before assembling the lamp post make sure the switch
is set in the “OFF” position. The ON/OFF switch is located
on the lantern top. Once the batteries are fully
charged, set the ON/OFF switch to “W” for white light
or “A” for amber light. If the lantern doesn’t turn on
after initial charging, ensure batteies are making
contact with the terminals.
Attach lower lamp post (E) to lamp post base (B) using
screws (K) in 3 places.
Place middle post (D) on the lower post (E) and twist
clockwise to secure.
Place upper post (C) on the middle post (D) and twist
clockwise to secure.
Place the completed lantern assembly (A) onto the
upper lamp ost (C) and twist clock wise to secure.
Remove the screws from the top of the lantern housing
(A) as shown.
Carefully Lift the top of the housing (D), and open the
three battery compartments.
Remove old batteries, replace batteries with new ones
of same rating. Reference polarity direction inside
battery compartment.
Replace lantern top and secure with screws.
Thread hex nut (H) onto the j-bolt (G). Make sure the hex nut is
threaded down the j-bolt far enough for the top of the j-bolt to
fit through the mounting plate (L) and the lamp post base (E)
with enough threads to secure the base to the j-bolts with
acorn nuts (I). Repeaat steps for other j-bolts.
Using mounting plate (L) as a guide insert the j-bolts with hex
nuts into a wet concrete pad until the hex nuts are blow pad
level.
Place the mounting plate (L) onto j-bolts forming a mounting
bracket.
Align the lamp post base (B) holes with the j-bolts and secure
with the acorn nuts (I).
B
E
K
K
D
C
A
ON
OFF
A
F
J
