4
Note: The below configuration MENU settings are the thermostat default settings – your installer may have changed one
or more of these settings to suit your specific heating installation (e.g. Menu 06-Maximum Floor temp should be limited
to 27C for wooden floor areas).
To enter into the setting menu, please follow these steps:
1. Turn the thermostat off by pressing .
2. Press and you will then see Menu 01.
3. Use and to adjust the sensor selection which is Menu 01 (Air Sensing, Air and Floor, or Floor Only.
4. Press to move to the next Menu. One you have all the menu options set, proceed to the next step.
5. Press to accept and store.
Configuration menu
(only to be adjusted by/in consultation with your heating installer)
352 Morphett Road, Warradale
T
08 8396 5617
E
Thermostat Setup Instructions
Menu #
Feature
Explanation
Recommended setting
01
Mode/Sensor Selection
This thermostat is a combination model which allows you to choose 3
different modes.
A mode = Air Sensing (built-in sensor)
AF mode = Air & Floor Sensing (floor probe must be installed)
F mode = Floor sensing (floor probe must be installed)
F
02
Switching Differential
The number of degrees difference before switching. The default is 1°C
which means the thermostat will switch the heating on 0.5°C below the set
temperature and will turn it off 0.5°C above the set temperature. With a 2°C
differential, the heating will switch on 1°C below the set temperature and
will switch off 1°C above the set temperature.
1°C
03
Air Temperature Calibration
This is to recalibrate the air temperature if required.
0°C
04
Floor Temperature Calibration
This is to recalibrate the floor temperature if required.
0°C
05
Temperature Readout
(AF mode only)
This gives you the option to show the Air Temperature, Floor Temperature
or to show both Air & Floor at intervals.
A = air temperature
F = floor temperature
A-F = shows both air and floor
in 5 second intervals
06
Maximum Floor Temp
(AF mode only)
This is to protect the floor surface.
35°C
07
Temperature Format
This allows the temperature to be set as °C or °F.
°C
08
Clock Format
You can select the clock to show either 12 or 24 hour time.
24-hour (default),
12- or 24-hour clock format
09
Frost Protection
This is to avoid your room temperature going below 5°C.
Off
10
5+2 / 7 Day Mode
This allows you to program either 5 days at once, then the 2 days of the
weekend separately, or the full 7 days at the same time or 7 days separately.
02
Recommended configuration
