SUNPUMPS PCA-60-M1 SERIES, Руководство по эксплуатации и установке

Страница: 9 / 18

1.
Switch the controller to the OFF position.
2.
Connect ground rod conductor to the controller chassis ground block.
3.
Connect solar module frame ground conductor to controller chassis ground block.
4.
Connect pump ground conductor to controller chassis ground block.
5.
Connect pump motor negative (-), black conductor to controller terminal labeled “LD-”.
6.
Connect pump motor positive (+), red conductor to controller terminal labeled “LD+”.
7.
Connect the DC source supply negative (-), black conductor to the controller terminal labeled “PV-“.
(NOTE: If a fused disconnect is used, the power should be connected to it first and then to the controller).
8.
Connect the DC source supply positive (+), red conductor to the controller terminal labeled “PV+“.
(NOTE: If a fused disconnect is used, the power should be connected to it first and then to the controller).
9.
Refer to the next section for “Remote Control” connections and “Adjustment Procedures” for
configuration (if applicable) and then return to this point.
10.
At this point, all system components are installed and wired, double check conductor polarities, wire
termination tightness and controller configuration. If you have a volt meter check the open circuit voltage
and the module polarity before connecting power to the controller.
11.
Switch the disconnect on and if the polarity is correct the red light will be on.
12.
Turn the “ON/OFF” switch to the ON position. The system should be operational. If the system is not
working refer to the “Troubleshooting” section.