Page 2 / 3
02/2020
ASSEMBLY
1. Lay Bottom Shelf (C) on the ground with the slats
facing upwards, as shown.
2. Locate the Inset End of Bottom Shelf (C) (see
diagram).
3. Connect both 2-Hole Shelf Support (B2) to the inside
of the inset ends by hand-tightening 2x JCBC M6 x
40mm Bolt (G).
4. Connect both 3-Hole Shelf Support (B1) to the
inside edge of Bottom Shelf (C), as shown, by hand-
tightening 2x JCBC M6 x 40mm Bolt (G).
5. Ensuring the closely-spaced holes are at the bottom,
connect each 5-Hole Shelf Support (A) to the inside
edge of the bottom shelf by hand-tightening 4x JCBC
M6 x 40mm Bolt (G).
Read carefully and understand assembly before beginning.
Please note: shelf supports install on the inside of all shelves.
Do not fully tighten any bolt all until all components have been assembled.
LY451
A:
4
B1:
2
B2:
2
G:
8
STEP 1
1. Place Single Shelf (D) over the 5-hole and 3-hole
shelf supports, as shown.
2. Secure the shelf to the shelf supports by hand-
tightening 6x JCBC M6 x 40mm Bolts (G).
D:
1
G:
6
STEP 2
Inset End
