5.
Slide the small tier over the water tube and firmly connect the light cable to the short cable on the pump.
6.
Gently place the small tier onto the column, ensuring all cables are inside the fountain. Do not allow the cables to get
caught/pinched between the tiers as this can damage the wires.
7. Place the rubber washer (from step 3) on the water tube. Twist the topper onto the water tube until it is secure; do not
over-tighten.
8. Firmly connect the pump power cable to the AC adapter.
9. Fill both tiers with enough water to keep the pump fully submerged during operation.
10. Plug the power cord into a properly grounded GFCI outlet.
03/2020
MZ15103BA
Page 2 / 2
Any modification to the product or failure to follow recommended care will void the product warranty.
IMPORTANT INFORMATION
USE & CARE
• For outdoor use only.
•
Some splashing is normal; adjust the flow rate on the pump if the water rate is too high.
•
Check the water level frequently to ensure the pump remains fully submerged; never allow the pump to run dry as it will burn
out the motor.
•
Only use water in this fountain. Distilled water will help prevent mineral buildup but is not required, avoid heavily chlorinated
water as it may damage the fountain or pump.
•
Periodically change the water to keep the fountain and pump clean. Remove scale and buildup regularly.
DO NOT use harmful additives such as bleach, chlorine, etc.
DO NOT use a pressure washer or abrasive materials to wash the fountain.
• Always shut off the power supply before cleaning and maintaining the fountain and the recirculating pump.
•
Take care when handling the pump; only pick it up by the body of the pump, never by the power cord.
•
During freezing weather, drain the fountain, disconnect the pump and store indoors; allowing ice to form may damage the
fountain in such ways as, but not limited to, the fountain cracking, permanent pump damage, and /or lighting malfunctions.
TROUBLESHOOTING
• Ensure that the pump is fully submerged and add water if necessary.
•
If water is not flowing within several moments of the fountain being plugged in, the pump may have trapped air which can
prevent water from circulating properly. Simply unplug the power supply for a few moments and plug it back in. Also check the
pump and tubing for obstructions.
•
If water is not flowing or water is splashing, check the flow control on the body of the pump; it may need to be adjusted to
achieve the desired flow rate.
•
If the light is not working, ensure the cables are fully connected and the seal is adequately tightened (do not over-tighten).
• Make sure the adapter cable is fully connected to the pump power cable.
•
Make sure the power outlet is working; if in doubt about electrical connections, consult a certified electrician.
WARNING!
Manufacturer and seller expressly disclaim any and all liability from personal injury, property damage or loss, whether direct or
indirect, or incidental, resulting from the incorrect attachment, improper use, inadequate maintenance, or neglect of this product.
Note
: When first used, there may be air in the pump. It may take several minutes for trapped air to escape, allowing water to flow.
You may need to add more water as the pump begins to circulate water through the fountain.
