1
5
3
4
2
Page 4 / 5
JCU-1001/9 LED
08/2020
This product uses a rechargeable battery.
When the battery can no longer be used, it
should be removed from the unit and recycled.
The battery must not be incinerated or composted.
Recycle the battery in accordance with local laws
and regulations.
Place the solar panel face-down on a soft, clean surface.
Remove (3) screws from the bottom of the panel.
Carefully lift the bottom of the panel, ensuring the wires
remain intact. Gently remove the old batteries. Paying
attention to the positive and negative terminals, insert
new batteries.
Twist the solar panel counterclockwise and gently lift the
panel off the umbrella. Take care not to pull on the cords.
Carefully disconnect the plug from the socket by pressing
the tabs surrounding the connection point. Pull apart by
holding the plug, never pull on the wires.
BATTERY REPLACEMENT
Change the batteries in the solar panel every year or when
the light output is diminished.
• Only install new batteries of the same type into the
product; (3) 'AA' Ni-MH 1600mAh rechargeable batteries.
• Failure to insert batteries in the correct polarity, as
indicated in the battery compartment, may shorten the
life of the batteries or cause batteries to leak.
• Do not mix old and new batteries.
• Do not mix Alkaline, Nickel Cadmium or Lithium
rechargeable batteries.
• Recycle batteries in accordance with local laws and
regulations.
Tools required: Phillips screwdriver (not included)
Carefully replace the bottom of the panel and align the
screw holes. Secure the panel with the screws removed
in step 3. Do not over-tighten the screws.