Any modification of this product or failure to follow the recommended care, safety and warning statements will void the product warranty.
4. CLEANING AND MAINTENANCE
5. TROUBLESHOOTING
Pump is not operating even though the solar panel is in full sunlight.
► Pump is submersed – ensure the pump is fully submersed in water as it will not operate if it is not.
► Cable connection secure – ensure the pump cable is securely attached to the solar panel.
► Impeller may be blocked – disassemble the pump as shown above. Use a small brush or stream of water to remove any debris.
Pump is operating but there is little or no water running through the fountainhead.
► Check pump for debris – check to ensure debris is not blocking the front of the pump.
► Check for the buildup of sediment or scale – check the pump, filter, tubes and fountainheads for blockages. Clear loose blockages by hand
and clean pump components. Fountain cleaning products are recommended for cleaning fountain components;
do not use bleach
to clean
this product as using bleach will invalidate the product warranty.
• Altering of this product or changing components is prohibited.
• Do not connect the pump to any AC voltage power; it is intended ONLY for DC voltage power.
• Do not pump with flammable liquids.
• Do not use pump with water above 35
°
C (95
°
F).
• During freezing weather, dry and store all components of the kit.
• Do not strike the solar panel.
• Do not lift the pump by the power cable.
• Operate the pump in freshwater only.
• Do not use bleach or corrosive chemicals to clean any components of the unit.
SAFETY & WARNING STATEMENTS
Operation Voltage
6V DC
Solar Module
1.3W
Max. Water Lift
0.5m
Max. Water Flow
150 L/H
Cable Length
5m
6. TECHNICAL DATA
02/2019
AMP-P001B1
Page 2 / 2
Solar Panel:
Clean the solar panel regularly to maintain optimum conversion of the suns energy into direct current to power the pump. Solar panels can be
come extremely hot in sunshine so it is recommended that cleaning be performed early in the morning, late in the evening or during a relatively
cool day.
The solar panel should only be cleaned with a soft tissue, soft cloth or soft sponge and a propriety glass cleaning solution. Take care not to
scratch the glass of the solar panel while cleaning.
Pump (6V DC):
After some time of use, if the pump starts losing power or stops working you should check for the buildup of sediment or scale in the filter and/or
in the pump housing. The filter housing can be removed by pressing down on the bottom of the filter housing.
To clear the impeller, open the pump housing at the front by sliding up the front plastic cover.
D
O NOT USE BLEACH to clean this product
