10
ADJUSTMENTS GUIDE
ADJUSTING THE RESISTANCE
Rotate the
Tension Control Knob (No. 5) clockwise
to
increase the level of resistance. Rotate the tension control
counter-clockwise
to decrease the level of resistance.
Tension levels are set at Level 1 being the lowest and
Level 8 being the highest.
ADJUSTING THE BALANCE
When this product is on an uneven surface, please adjust
both
End Caps (No. 24)
according to the left instruction
picture.
REPLACE THE BATTERY
Two AA batteries are included in the
Computer (No. 1)
.
To replace the batteries, replace both batteries from the back
of
Computer (No. 1)
. Do no mix battery types and do not mix
old and new batteries.
Dispose or recycle batteries according to your state and local
guidelines.
MOVING THE MACHINE
To move the machine, lift the
Rear Stabilizer (No. 23)
until
End Caps (No. 18)
touch the ground. With the
End Caps
(No. 18)
on the ground, you can transport the bike to the
desired location with ease.
ADJUSTING THE SEAT
Push the
Adjusted Handlebar (No. 46)
down to loosen
(see
Fig 1
). Keep your feet on the floor as leverage, then
move the
Backrest Frame Support (No. 38)
to the
desired position. Pull the
Adjusted Handlebar (No. 46)
up to tighten (see
Fig 2
).
24
1
Fig 1
Fig 2
18
23
46
38
46
38
