9
ADJUSTMENTS & USAGE GUIDE
1.If you find there is no difference between tension level 1 to level 8, check the connection of the
tension cable. See Diagram below.
2.If the meter does not show numbers correctly, check the batteries. If the meter does not count
the speed and time, check the connections of
Extension Wire (No. 18)
to the
Computer (No. 9)
and
Extension Wire (No. 18)
to
Sensor Wire (No. 20)
.
3.If you have difficulty putting
Hinge Bolts (No. 38L/R)
into the
Crank (No. 22)
, try moving the
Crank (No. 22)
to a different angle. Keep in mind the
Left Hinge Bolt (No. 38L)
has reverse
threading and must be installed by turning counter-clockwise.
4.If you hear any noise when using the machine, please check if
Hinge Bolts (No. 38L/R)
,
Hex
Bolt (No. 30)
,
Hex Bolt (No. 24)
and
Connecting Joint (No. 40)
are loose. You may remove
these parts and add some lubricant oil to eliminate all noise possibilities, remember to tighten all
the parts securely.
5.When you first use the machine, if you hear any unusual noises from the inside of the
Chain
Cover (No. 66L/R)
, please loosen the screws on the chain cover about two rotations, then push
the
Chain Cover (No. 66L/R)
up a little bit; finally, fasten the screws you loosened before. See the
following diagram. (During shipping, the
Chain Cover (No. 66L/R)
can be dislocated, and the
Flywheel (No. 96)
may rub on the
Chain Cover (No. 66L/R)
.
Содержание SF-E3607
Страница 3: ...2 EXPLODED DIAGRAM ...
