Centralizer Points and turn both Points at same time
until new wear surfaces will contact walls of bore
(see Figure 4)
.
Adjust Tension on Centralizer Points -
For fast,
easy gaging with least wear on centralizer points,
tension should be adjusted to fit job you're doing:
When gaging horizontal bores, tension should be
light . . . turn Tension Control until the Line is at
bottom of Window
(see Figure 5)
.
When gaging vertical bores, more tension is needed
to make centralizer points come out and make
proper contact. Turn Tension Control until there is
enough tension to keep centralizer points extended.
The Line will then be close to top of Window
(see
Figure 6
).
To Rotate Gage Point Ball -
When a gage point
Ball gets a flat worn on it, Ball can be rotated to a
new position, as follows:
NOTE:
While performing this operation, hold gage
over a clean cloth in case Ball should be dropped.
1. Hold thumb over Ball and pry it out with Gage
Point Ball Tool (see Figure 7).
2. Rotate Ball so an unworn area will protrude
from gage point. Reinstall Ball by pressing in with
blade of Gage Point Ball Tool.
3. Seat Ball by pressing it against hard surface.
To rotate Indicating Finger Ball -
When
Indicating Finger Ball gets a flat worn on it, Ball
can be rotated to a new position, as follows:
NOTE:
While performing this operation, hold gage
over a clean cloth in case Ball should be dropped.
1. Insert Indicating Finger Ball Tool into Slot and
pry upward to remove Ball. Ball will stay in Tool
(see Figure 8)
.
2. Rotate Ball so unworn area will protrude from
Indicating Finger.
3. Depress Centralizer Yoke and insert Gage Point
Ball Tool to prevent damage to gage when
reinstalling Ball
(see Figure 9)
.
4. With Ball still captivated in Indicating Finger
Ball Tool, reinsert Tool into Slot, locating Ball over
Ball Socket. Press Ball firmly into place and
remove Indicating Finger Ball Tool.
5. Make sure Ball is seated by pressing it down
firmly with flat back of Indicating Finger Ball Tool.
6. Remove Gage Point Ball Tool.
FIGURE 6
FIGURE 7
FIGURE 5
FIGURE 8
FIGURE 9
“SUNNEN AND THE SUNNEN LOGO ARE REGISTERED TRADEMARKS OF SUNNEN PRODUCTS COMPANY.”
SUNNEN PRODUCTS COMPANY
7910 Manchester Rd. • St. Louis, MO 63143 U.S.A. • Ph: 314-781-2100 • Fax: 314-781-2268
U.S.A. Toll-Free Sales and Service – Auto: 1-800-772-2878 • Ind: 1-800-325-3670
International Division Fax: 314-781-6128
PRINTED IN U.S.A. 0608
©COPYRIGHT SUNNEN
®
PRODUCTS COMPANY 2006, ALL RIGHTS RESERVED
Sunnen
®
reserves the right to change or revise specifications and
product design in connection with any feature of our products
contained herein. Such changes do not entitle the buyer to
corresponding changes, improvements, additions, or replacements
for equipment, supplies or accessories previously sold. Information
contained herein is considered to be accurate based on available
information at the time of printing. Should any discrepancy of
information arise, Sunnen recommends that user verify the
discrepancy with Sunnen before proceeding.
