Production Number: XXXXXXXX
Made In China
10
/
13
LOCATION
Your Gas appliance must be installed on a flat, stable surface, away from any combustible materials or construction.
SET-UP
Your Gas appliance comes assembled, ready for a Gas connection.
1-
Remove the appliance from container box and place it on any level, outdoor, non-combustible surface.
NOTE: Do not place this appliance on grass or dirt area. This may prevent proper safety venting.
2-
Open the gas door and put the cylinder inside.
3-
Unscrew the battery box as shown in Fig 1.Insert the negative electrode side of the battery into the bottom of battery
box as shown in Fig 2. Then screw the battery box as shown in Fig 3.
Fig 1 Fig 2 Fig 3
Note: If the battery of the pulse electronic igniter runs out of power, please replace the new battery as above.
Gas Connection
1-
Open the door and control valve outside. See Fig 4.
2-
Put the cylinder into the cylinder rack. See Fig 5.
3-
Connect the regulator and the cylinder as per Fig.6. Make sure there is no leakage or damage (please refer to “Leak Test”
on page 13 and the damage checking on page 4).
4-
Turn the butterfly nut on the cylinder frame, so that the nut is held against the bottom of the cylinder, to make sure the
cylinder can be fixed. See Fig 7.
5-
Disconnect the regulator and the cylinder as per Fig.8.
Fig.5
Fig.4
Fig.6
Fig 6
