sunjoe SBJ801E, Руководство оператора, Страница: 9 / 16

9
1. To release the collection bag, push the release button and
pull the bag off the unit by the handle at the same time
(Fig. 10).
2. To attach the collection bag, align the two collection bag
feet into the notches on the bottom of the unit body, and
insert the collection handle tab into the locking slot under
the collection bag release button, and connect to the unit
body, as shown (Fig. 11).
3. Push firmly until the bag clicks into place on the unit body.
NOTE: The collection bag must be attached any time the
unit is being operated in vacuum mode.
Maintenance
To order genuine replacement parts or accessories for the
Sun Joe
®
SBJ801E electric mulcher,
please visit snowjoe.com or contact the Snow Joe
®
+
Sun Joe
®
customer service center at 1-866-SNOWJOE
(1-866-766-9563).
m
WARNING!
Disconnect the extension cord before
performing any maintenance task.
If the extension cord is plugged into the appliance, someone
could accidentally turn on the unit while you are performing
maintenance on it, which could result in serious personal
injury.
Clearing The Blocked Inlet/Outlet
During the vacuuming process, certain objects such as cloth,
rope or large diameter sticks may obstruct and block the air
inlet/outlet. A thermal protection device, which is built into the
blower vac, will cut off the electricity to the motor to prevent
damage from overheating. When this happens, follow the
instructions below to clean the blocked air inlet/outlet.
m
WARNING!
To avoid serious personal injury, be sure the
unit is OFF and unplugged before clearing the air inlet/outlet.
m
WARNING!
To avoid serious personal injury, always
wear gloves to protect yourself from any sharp objects.
1. Slide the ON/OFF switch down to the OFF (O) position
until the unit comes to a complete stop.
2. Unplug the unit.
3. Remove the collection bag.
4. Using protective gloves, carefully remove the material
blocking the air inlet/outlet. Inspect to ensure no damage
has occurred.
5. Reinstall the collection bag.
6. Wait 3 minutes for the motor to cool.
7.
Plug the unit back into the power supply and turn the ON/
OFF switch to ON (I). The blower vac will resume normal
function.
Cleaning the Unit
m
WARNING!
To avoid serious personal injury, always
turn the unit off and unplug it before cleaning or servicing.
Use a small brush to clean the outside of the unit. Do not use
strong detergents, household cleaners that contain aromatic
oils (e.g. pine and lemon) or harsh solvents such as kerosene
as these substances can damage the plastic housing or the
handle. Wipe off any moisture with a soft, dry cloth.
1. Empty the bag after each use to avoid deterioration and
obstructing air flow, which will reduce the performance of
the mulcher.
2. Wear eye protection and a dust mask. Clean the bag as
needed. Turn the bag inside out after initial emptying and
vigorously shake out dust and debris.
3. Wash the bag once a year, or more often if needed. Follow
the steps below:
i. Remove the bag.
ii. Unclip the 6 velcro clips used to secure the bag on
the plastic frame. Remove the collection bag from the
frame.
iii. Turn the bag inside out.
iv.
Hang it up.
v. Hose it down thoroughly.
vi. Leave it hanging to dry.
vii. Turn the bag right-side out and reinstall.
Fig. 10
Collection bag
release button
Handle
Fig. 11
Foot
Notch
Locking slot
Collection
bag
Handle tab