sunjoe 24V-WDV6000, Руководство оператора

Страница: 11 / 24

11
7. Connect the preferred nozzle with the other end of the
suction hose. If needed, use the equipped telescopic tube
and the air regulation handle, as shown (Fig. 9).
NOTE: This unit is equipped with 3 nozzles. The utility nozzle
is for vacuuming solids and liquids over medium and larger
areas. The crevice nozzle is for vacuuming solids and liquids
in corners, edges and other areas that are difficult to access.
The dust brush is good for collecting light material while
vacuuming.
Operation
m
WARNING!
DO NOT vacuum hazardous substances.
This cordless wet/dry vacuum is designed to clean hard
surfaces. It is only suitable for vacuuming wet or dry light
materials. The vacuuming of heavy materials such as metal,
stones, branches, broken glass is expressly excluded.
Do not switch on the wet/dry vacuum until it has been
completely assembled. Before switching on the unit, always
check the filter is assembled securely.
m
WARNING!
Use the wet/dry vacuum only in daylight or
good artificial light.
• Make sure the powerhead is properly installed and
secured when using. Make sure each latch is locked.
Failure to properly secure the locks could cause the
powerhead to release from the tank.
• Double check to make sure the filters are not broken or
torn. Do not use filters that are broken or torn. Handle the
filters carefully when removing and installing.
• To reduce the risk of hearing loss associated with sound
level(s), hearing protection is required.
• Be extremely careful when working on slopes and stairs.
• Always move forward by walking. Never run.
• Clean up after using the wet/dry vacuum. Dispose of
debris appropriately.
• Always use the carrying handle for transporting the
equipment.
m
WARNING!
To avoid personal injury, wear ear
protectors when operating this unit. Wear a face mask or dust
mask in dusty locations.
Dry Vacuuming Mode
m
WARNING!
Make sure to assemble the cartridge
filter properly when using the equipment for dry vacuuming.
The use of incorrect filter will damage the unit and void the
warranty.
The cartridge filter should be pre-assembled on the filter cage.
If not, follow the instruction below to assemble the cartridge
filter.
1. Make sure the battery is removed from the compartment.
2.
Unlock the powerhead by flipping up the latches on both
sides, and then lift up (Fig. 3).
3. Turn the powerhead upside down. Put the filter basket
onto the cartridge filter. Push down until the filter sits
securely. Insert the cartridge filter lock. Turn clockwise to
secure (Figs. 10 - 11).
Fig. 9
Suction hose
Air
regulation
handle
(optional)
Telescopic
tube (optional)
Utility nozzle
Dust brush
Crevice nozzle
Fig. 10
Powerhead
Filter basket
Cartridge filter
Cartridge
filter lock