sunjoe 20ViONLTE-CS10, Руководство оператора

Страница: 13 / 24

13
8. Timely recharging of the battery will help prolong the
battery's life. You must recharge the battery pack when
you notice a drop in the equipment's power.
IMPORTANT! Never allow the battery pack to become fully
discharged as this will cause irreversible damage to the
battery.
Charging a Hot or Cold Battery Pack
A red and green flashing indicator light on the charger base
indicates that the battery pack temperature is outside the
charging range. Once the pack is within the acceptable
range, normal charging will take place and the red light will
be continuous. Hot or cold battery packs may take longer to
charge.
Operation
Starting and Stopping
m
CAUTION!
Starting, stopping, and restarting an electric
motor repeatedly within a few seconds can generate a great
deal of heat and damage the motor. To protect the life of your
cordless chain s aw, always wait at least five seconds after
stopping before restarting the saw.
m
WARNING!
Be sure that the chain is not in contact with
any object when you start the motor.
m
WARNING!
Keep hands away from chain. Keep hands
on handles. Do not overreach.
A good, firm grip on the tool using both hands will help you
maintain control. Maintain a firm grip by place your right hand
on the rear handle and left hand on the front handle with
thumbs and fingers encircling the respective handles. A firm
grip combined with proper positioning of the handle against
your body will help you maintain control of the saw. Do not let
go of the saw while it is in operation.
m
WARNING!
Do not operate the cordless chain saw in
a tree, on a ladder, or on a scaffold. Using the tool under such
circumstances is extremely dangerous.
m
CAUTION!
The chain will continue to run for several
seconds after turning off the tool.
Do not use the chain saw under wet conditions. Use extreme
caution when cutting small brush, saplings, or limbs under
tension because slender and tense material may catch the saw
and be whipped toward you, pull you off balance, or spring
back.
Do not use the chain saw to cut vines and/or small
underbrush.
m
WARNING!
Do not let familiarity with this type of tool
prevent you from taking all necessary precautions. Remember
that a careless fraction of a second is sufficient to inflict
serious injury.
m
WARNING!
Do not cut trees near electrical wires.
m
WARNING!
Failure to lubricate the chain will cause
damage to the bar and chain. Use only a good quality bar
and chain oil designed specifically for use with chain saws.
NOTE: It is normal for oil to seep from the saw when not in
use. To prevent seepage, empty the oil tank after each use.
When storing the unit for a long period of time (3 months or
longer), be sure the chain is lightly lubricated; this will prevent
rust on the chain and bar sprocket.
1. Prior to each cutting session, run through the daily
checklist (see pg. 19).
2. Insert the battery in the battery compartment (Fig. 17).
3. To turn the tool on, hold the chain saw firmly with both
hands. Press the safety lock button, then push the trigger
switch. When the chain saw is running, you can release
the safety lock button (Fig. 18).
4. To turn the tool off, simply release the trigger switch.
NOTE: Do not press the trigger switch until you are ready
to make a cut.
Battery Pack
Temperature
Lithium-Ion Charging Status
Too hot Flashing Not charging
Normal range Red Normal charging
Too cold Flashing Not charging
Charger Base
Indicator Light
Charging
Status
Fig. 17
Safety lock button
Fig. 18
Trigger
switch