___________________________________________________________________________________
24
4.1 Configure COM / LPT Port Settings
After the board drivers are installed, please refer to following
instructions to
configure Serial COM and Parallel LPT port settings.
(1) Please launch the “
Device Manager
”.
(2) Right click the “
SUNIX 2-port RS-232 Serial Card / 1-port Parallel
Multi-IO Card
” item from the “
Multifunction adapters
” sub-tree and click
“
Properties
”.
(3) On the “
Port Control
” tab, select a port to configure. You can set both
COM and LPT ports settings through this page.
* Click “
OK
” to approve the settings for the selected port.
* Click “
Apply to All
” to approve the settings for all COM and LPT ports.